WOOD IMPREGNANT OIL- OWATROL D-1, 1 l

Owatrol D-1 is high-quality saturating wood oil for interior and exterior tropical woods. Can be applied to both horizontal or vertical surfaces. Saturates and protects all woods - Soft and Hard. Oily and Dense. Excellent penetration - non-film forming. Replaces the natural oils lost from the wood - will not blacken the timber. Transparent - Enhances the woods natural grain. Deep penetrating, stabilises the timber - Protects against moisture ingress. Easy maintenance - no sanding or stripping. Used alone, gives a silken matt finish or overcoat with Owatrol D-2 for a high gloss finish. Where to use: Hardwoods and tropical timber- Oak, Chestnut, Teak, Mahogany, Movingui, Ipe, Bangkirai etc., Softwoods : Pine, Spruce, Larch etc., Exterior: garden furniture, patios, walkways, boat decks, topsides on boats, portals etc., Interior: flooring, paneling, stairs, doors, windows, door frames etc., Marine: Can be applied above or below the waterline. Excellent primer for conventional single pack marine coatings. Direct on prepared woods. Coverage rate for maintenance: 8 to 12 m²/l - Multicoat coverage: 1 to 4 m²/l, Application temperature: +5°C to +35°C, Drying: 24 h. - Setting up time before use: 3 days. Apply a coat of D-1 - Allow to penetrate for 15-30 minutes. Apply a second application. Allow to penetrate for 15-30 minutes. Repeat this procedure until the wood is saturated i.e. will accept no more oil. Once the timber is saturated, always brush out or wipe up any excess product that has not penetrated to avoid shiny spots. Do not allow D-1 to become touch dry or dry between coats (apply "wet on wet").